离子氮化后轴表面形成微坑的分析及解决措施

茹学锋, 郭强. 离子氮化后轴表面形成微坑的分析及解决措施[J]. 金属加工（热加工）, 2007, (8): 61-61.

引用本文:

茹学锋, 郭强. 离子氮化后轴表面形成微坑的分析及解决措施[J]. 金属加工（热加工）, 2007, (8): 61-61.

Analysis on micro-pits on back shaft surface after nitriding and its solution[J]. MW Metal Forming, 2007, (8): 61-61.

Citation:

Analysis on micro-pits on back shaft surface after nitriding and its solution[J]. MW Metal Forming, 2007, (8): 61-61.

Analysis on micro-pits on back shaft surface after nitriding and its solution

摘要: 我厂生产的一种轴采用0Cr17Ni4Cu4Nb的棒材机加而成.轴的生产工艺流程为:下料→机加→固溶→机加→时效→机加→离子氮化→磨削、抛光→检验→包装入库.

用微信扫码二维码

分享至好友和朋友圈